Pre-Installation Setup for EMC NetWorker > Installation Overview (EMC NetWorker)
  
Version 10.2.01P10
Installation Overview (EMC NetWorker)
1. Updating the Local Hosts File for Data Collection
2. Add EMC NetWorker Servers
3. In the Portal, add a Data Collector, if one has not already been created. See Adding/Editing Data Collectors.
4. In the Portal, add the EMC NetWorker data collector policy. See Adding an EMC NetWorker Data Collector Policy.
5. Configure a Notification Action in EMC NetWorker
6. On the Data Collector Server, install the Data Collector software. See Installing Data Collectors.
7. Validate the Data Collector Installation. See Validating Data Collection.
Note: These steps apply only if you are performing an IN-HOUSE installation. If a third-party service provider is hosting your Portal—that is, a HOSTED installation (perhaps for a product evaluation)—skip this section and contact your hosting organization’s representative to configure the hosted Portal for your Data Collector.
Add EMC NetWorker Servers
For each NetWorker Server specified in the Data Collector Pre-Installation worksheet, add the NetWorker server(s) to APTARE IT Analytics.
1. In the Inventory, add a host for each NetWorker server (Utility Node). See Managing Hosts and Backup Servers.
• Host Name - Displayed in the Portal.
• Internal Host Name - Must match the host name of the NetWorker server; fully qualified domain name (FQDN).
• Backup Type - NetWorker Server
2. Continue to the next step: Adding an EMC NetWorker Data Collector Policy.